Z-INKS AQUATINGS 227 has been formulated for application via ink ducts and can be applied in-line over wet ink as well as off-line. The coating dries via a combination of penetration and evaporation and requires accelerated dryers in the form of hot air knives and IR lamps. Optimum stack temperatures are 28-32°C. A slight application of a medium to large sized spray powder is recommended.

Z-INKS AQUATINGS 227 can be applied as a dry solid using a rough grained aluminium plate or as a spot image by stripping a blanket or by employing a photo-polymer plate.

Upon starting up, it is recommended to apply a heavier than usual film weight. This will assist with any initial drying/stability problems. The film weight can be reduced as required. During press stops, the plate and blanket should be cleaned using either warm water or a dedicated wash. Upon starting up the rollers should be sprayed with a fresh start retarder in order to ensure a clean start up.

Z-INKS AQUATINGS 227 contains silicones that are unsuitable for gluing or foil blocking.

Waterbased emulsions should not be exposed to temperatures below 5°C or above 35°C. During cold months, it is recommended that containers are kept off of cold oors and stored on pallets. All emulsions have a 12 month shelf life - if unopened and stored in the correct conditions. Manufacture date is available on the label. Waterbased emulsions are non-hazardous and require no special storage or labelling.

The information contained in this product data sheet is correct to the best of our knowledge at the date of issue. It is intended as a guide for the optimum use of the named product and is not intended as a warranty or as a specification. The information relates only to the product specified and may not be suitable for combinations with other materials or in processes other than those specifically described herein.